Questions & Answers for: Brother drum is defective

...defective [drum cleaning blade] especcially if it's a refilled unit. There might be a small blue tab on top of the unit that you can slide back and forth to clean the charge wire. But then again, if ...

Drum may be defective must be repalced. When replacing drum, be sure to reset the drum counter for HL 5150D: -Open the toner compartment door, and hold the go button for 5 seconds. Sounds like the new

...Could be a defective drum, but do the reset first, Open the front door and hold the go button until the lights flash and it will be reset. after that just shake the toner and hope for the

...alcohol and soft cloth is ok. Water is a no-no. The wiper blade may be defective on the drum unit and or the excess toner cavity in the rear of the drum may be full. Best bet is to replace the

...doesn't locks in place. what should i do? The silver bar is part of the drum assembly, if the holders are broken you need to return the defective drum. That part of the drum case can't be

...the panel. 3 - Press 1 to reset 4 - Close the front cover done. If the issue persists after resetting your drum contact brother technical support you may have a defective drum unit. Thanks, ...

...Try swapping the black and the magenta (red) cartridge. This will not damage the printer and you can see if the toner or the drum is defective. If you get a red page, drum Black page, toner ...

Unit has about 20k copies. Just replaced toner and drum. Keep getting "drum error", and tells me to take out drum and slide blue tab back and forth, which I do. Then when I put the drum back

...alsoa new drum and getting streaks down the printed page Is this a manufactured or offbrand drum? It either got something on the drum or the drum was sent defective new and needs to be

...defective drum or cleaner blade? if the cartridge is almost empty, then the toner start to become weaker so the toner is attracted on the surface of the drum. check the counter if it is time to ...