Questions & Answers for: drum is defective

Ad

Question about Office Equipment & Supplies

1 Answer

defective ? ID sensor dirty ? Defect at ID sensor pattern writing The problem is with your id sensor , it is sitting on the back side of the drum , in other words the further side of the drum when you

Ad

Question about FS-4000DN Laser Printer

1 Answer

EEPROM does not communicate nor mally. Defective connection drum PWB(YC1) and Connect-L PWB(YC3). Maybe defective drum PWB EEPROM or defective engine PWB or itis just the drum unit itself is defective

Ad

Question about KYOCERA/MITA - FS-4000DN Mono 47ppm, 500mhz Printer

1 Answer

Defective drum motor drive transmission system. solution Check if the gears rotate smoothly. If not,grease the bushings and gears. Check for broken gears and replace if any. cause Defective drum motor

Question about AR-5320 Black and White Copier

1 Answer

...drum marking sensor defective) Detail Usually the sensor gain is adjusted so that the output is a certain value, by reading the drum base surface with the drum marking sensor before starting process ...

Question about FS-4000DN Laser Printer

1 Answer

...Defective drum PWB EEPROM. - Defective engine PWB. Check procedures/corrective measures: - Install the drum unit - Check the connection of connectors drum PWB (YC1) and connect-L PWB (YC3). - Replace ...

Question about FS-2000D Laser Printer

1 Answer

...Defective drum PWB EEPROM. - Defective engine PWB. Check procedures/corrective measures: - Install the drum unit - Check the connection of connectors drum PWB (YC1) and connect-L PWB (YC3). - Replace ...

...drum d,not turn broken belt , defective timer, defective board if electronic, defective push button start switch, defective  cintrifugal switch in the motor itsself, defective motor, foreign ...

...drum PWB (YC1) and connect-L PWB (YC3). (See page P.1-4-9, refer to figure 1-4-5) Defective drum PWB EEPROM. Replace the drum unit (See page P.1-5-10). Defective engine PWB. Replace the engine ...

Question about FS-2000D Laser Printer

1 Answer

...signal error from the drum motor for 2 seconds after the drum motor turned on. Overload on the motor Defective drum motor Defective harness Defective IOB Try removing the drum and turning the

Question about FS-2000D Laser Printer

1 Answer

...rotating the drum backwards it stays with the ribs on the drum, when i rotate the way the motor turns the drum it flips the belt to rib side up Could be a worn or defective belt or a defect in the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

jasbo
jasbo

Level 3 Expert

2239 Answers

Ekse

Level 3 Expert

13434 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...