...- fault is a horizontal defect in the middle of the page every 95mm (3.75"), I inspected the ITB & drums, and replaced the fuser assy. Which roller is 3.75" or 95mm diameter? is this still
...drum assy check for foreign objects under toner/drum assy make sure toner is locked and drum is seated correctly also, check the small door on the left side of drum if stuck closed, gently push open ...
...cart. Take out the key that prevents you from putting drums in wrong slot and swap the whole drum and toner assy with another color, if it follows the magenta unit then that is the problem
Question about OKIFAX 5650 Plain Paper LED Fax
...have been cleaned but that points towards an inkjet MFP, if it is a laser MFP, take the toner/drum assy out and shake it hard.. the toner may have settled in storage and may be causing the
...area will be hot. This area is clearly marked. Do not touch it. CAUTION! Never expose the image drum unit to light for more than 5 minutes. Never expose the image drum unit to direct sunlight. ...
Question about C9600hdn Laser Printer
...Assy. • YES Replace Image Drum Unit. Note! 1. When replacing the Engine PCB (S2V PWB), remove the EEPROM from the old PCB, then mount that EEPROM on the new PCB. 2. If the EEPROM is not going to be ...
Question about C9600hdn Laser Printer
...will see the first roller directly above the chrome roller. Its usually in two pieces. Remove the drums and belt to see the second roller. Use platen roller cleaner to clean these rollers and ...
Usually answered in minutes!
259 Questions
172 Questions
152 Questions
147 Questions
126 Questions