timing belt broke do i have to drop the motor in my 89 mr2 to change the timing belt No, you can do it in the car, it just makes it a lot easier to do if you drop the motor out. Space is at a premium ...
dropping the motor how hard is it to drop the motor ? i looked and it does not look to hard, just wondering what about the wiring harness. its not to hard if u drop it out the bottom of the car wiring
WHEN STARTED THE ITS OK ON IDLE,THEN AFTER RUNNING FOR A WHILE, RPM DROPS THEN IT RUNS RICH THEN STALLS.SOME TIMES IT WONT START AS IF ITS FLOODING.WHEN RUNNING SOME TIMES IT MAKES A INDUCTION NOISE. ...
...G reg MR2 G limited import. Whilst driving along the speedo shot up and down a few times and then dropped until the needle was a below zero, it hasn't moved since. There was a whirring noise behind ...
...timing belt, thermostat, coolant hose and head job done at the same time. My friend has a valve dropped into the cyc! It's NOT a good pretty
...for the engine speed to drop when oil filler cap is removed? That is normal, when the oil cap is dropped the vacuum to the engine drops also cause the idle air valve to close due to lack of
What should my oil Pressure be? It will be halfway when first started up, but drops under half when warmed up. is this normal for this car? its normal for an old car where their is plenty of wear with
to fit a new clutch to 2003 mr2 with engin still in car You got to drop both then separate trans axle, is the way we do it.
my 1986 toyota Mr2 has a horrible synthetic oil leak. i believe its coming from the crankshaft pulley seal. can i take the crankshaft pulley off the engine without removing the engine from the car? ...
changing toyota spyder headlight Front bumper needs to be dropped. I have an 02 and I just let the dealer do it. I purchased the four light before hand and negotiated a price with a dealer to do the ...
Usually answered in minutes!
231 Questions
106 Questions
71 Questions
76 Questions
60 Questions