Questions & Answers for: Yamaha drive shaft Motorcycles

...shaft drive (cardan) for my Yamaha Dragstar Hi, I have a problem with the driveshaft for my 2003 Yamaha 650 Dragstar Classic. I have to replace it with another but only found a second hand shaft from ...

...drive shaft 2000 Yamaha v star 1100 classic, some mechanic said something about either replacing or lubricating the U joint when replacing the drive shaft, does this sound familiar to you? Also what ...

...drive shaft. The first step is to get your rear wheel off the ground. The easiest way to do this is to put your bike on its center stand. However, not all bikes have center stands. If your bike does ...

...drive shaft dust cover cut in 2 pieces, it's the metal tube the drive shaft goes into. I was informed by Yamaha no big deal, just a cover. When I picked up the bike they had replaced the whole drive ...

Drive shaft spins but bike wont move Here is a diagram of the parts associated wiyh the drive shaft and final drive assembly. Does the drive shaft rattle aroung inside the tube when the engine runs ?

...drive shaft will come out with the final drive, not a problem. Once you get the assembly off the bike, you can remove the axle then separate the final drive from the rear wheel and do what you needed ...

...I drain it from? Drain is on the bottom of the drive shaft. Fill is on the side of the drive shaft. Fill the shaft drive assembly to the bottom of the threads of the fill hole. Takes about

...Drive shaft Hello, I have a 2004 Yamaha V star 650 classic that needs to have it's final drive shaft replaced!!!! Can I buy a used FINAL DRIVE SHAFT for a V star 1100 and put that on my 650?! I can't ...

drive shaft is spinning freely will not engage Hi, Peggy for more information about your question and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a

...drive shaft steadily turning Hi, Peggy you may have broken a U- Joint in the drive shaft for this scenario you will need your service/owners manual if you can't find the first and best tool you ever ...