Questions & Answers for: Chevrolet drive pulley

...pulley. Removal & Installation 1.6L Engine A/C Compressor Belt Disconnect the negative battery cable. Loosen the A/C compressor mounting bolts. Pivot the A/C compressor towards the engine in order to ...

...drive square that's welded to it if you don't have a strong forearm. This runs about $20. It might actually be easier to slip the belt under the belt tensioner. Prying the tensioner back and slipping ...

drive pulley spins and slides forward and back to motorwhich in turn throws belt off so what i need to know is how to replace drive pulley or if it is repairable with a lock key Which pulley are you ...

...drive tensioner is and to remove tension to the belt at this point. If you remove the belt, it's easy to put the new one on because the pulleys are designed with grooves for the groove side of the ...

...drive pulley from the pump. NOTE When installing the puller tool onto the power steering pump pulley, be sure that the pilot bolt bottoms in the pump shaft by turning the head of the pilot bolt. ...

...drive pulley from the pump. NOTE: When installing the puller tool onto the power steering pump pulley, be sure that the pilot bolt bottoms in the pump shaft by turning the head of the pilot bolt. ...

...drive pulley bolts Water pump drive pulley Radiator inlet hose clamp and hose from the water pump Water pump mounting bolts Water pump Water pump gasket To Install: Clean the mating surfaces. Install ...

pulley bolts. 4. Remove the drive belt. 5. Remove the water pump pulleybolts and remove the water pump pulley. 6. Remove thewater pump bolts then Remove the water pump. 7. Remove the water pump gasket

...pulley bolts. Rotate the drive belt tensioner to release the tension on the drive belt. Remove the drive belt from the right idler pulley. Carefully release the drive belt tensioner spring tension. ...

...the drive belt broke...can you replace the belt without replacing the a/c compressor? Yes as long as the a/c pulley spins freely. You should be able to spin all pulleys by hand, except for crank ...