Questions & Answers for: Mazda Protege drain radiator

Question about 1998 Protege

1 Answer

...radiator which I put a 50/50 mix of antifreeze into. When the vehicle reached the temp. needed to open the thermostat one of the two fans went on and stayed on. I bypassed the running fan to the not ...

Ad

...drain quicker. Then follow the radiator hose from the BOTTOM of the radiator to the engine block. That is where it is located. The hose will connect to a cap held on by 2 or 3 bolts. Remove that to ...

Ad

Question about 1996 Protege

1 Answer

how to change a car radiator 4 steps 1,drain it,2,remove hoses,3,unbolt it,4,and take it out

...drain bucket is beneath the radiator neck in the event antifreeze purges air bubbles from the system. Add new 50 percent mixed antifreeze and 50 percent water to the radiator. Add it slowly, using a ...

Question about 1994 Protege

1 Answer

...drain out dirt and rusts. If you think that the radiator served youenough then it's better to have it replaced. Please do check the radiator hoses, If you have worn outhoses it can cause coolant ...

...radiator drain plug. Normally, this drain plug is located on the inside bottom of the radiator, but models will vary. Once the drain plug is unscrewed, coolant will rush out into the drain pan. If ...

Question about 1996 Protege

1 Answer

...radiator flushed to drain out dirt and rusts. If you think that the radiator served you enough then it's better to have it replaced. Please do check the radiator hoses, If you have worn out hoses ...

Question about 2002 Protege

1 Answer

drain and refill , if there is presence of rust please have a good flushing of the radiator or else the chances are that the radiator ports can be blocked and reduce the efficiency of the cooling . 5.

...Drain cooling system and remove lower radiator hose from thermostat housing.2. Remove bolts and thermostat housing3. Remove thermostat. 4. Reverse procedure to install new thermostat5. Fill and bleed ...

Question about 2003 Protege

1 Answer

radiator on mazada proetge 2003 remove cooling fans, loosen upper and lower rad hoses (before you pull them off, drain coolant) disconnect two trans lines if it is an auto. remove two rad brackets and

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...