...drain the primary and replace the plug. Remove the five bolts holding the derby cover on and fill the primary with H-D primary lubricant up to the bottom of the clutch spring. Look at the clutch ...
...drain the primary, remove the drain plug at the rear of the primary on the bottom. Replace the drain plug and refill the primary with oil until it's just to the bottom of this diaphragm spring. ...
Question about 2006 FXDCI Dyna Super Glide Custom
...primary. Drain the oil here and replace the plug. Add the oil at the top primary chain inspection port, large plug with a large "screwdriver" slot or two small bolts in it. Add 32-36 ounces of H-D ...
Question about 2000 FXST Softail Standard
...primary, the drain plug is underneath the primary at the rear. Drain the oil, Remove the derby cover and refill with one quart of H-D Syn3 20W50 engine oil. Good Luck Steve The drain is under the ...
...primary oil drain is a small pipe plug underneath the lowest part of the primary drive cover. The engine holds three quarts of oil, the transmission holds 20-24 ounces of oil, and the primary hold ...
...Primary Drain Plug? Oil drain plug is located to the front or left side of the Dyna's oil pan. The drain plug for the primary is near the lowest point of the primary cover itself. Be careful, what ...
...PRIMARY drain & the other is secondary drain.If the primary drain becomes CLOGED or slows down the 2nd drain leaks.Its time to clean out the primary drain tube.Find the end or disconnect it & ...
...primary share the same oil. To drain it, find the drain plug on the bottom of the primary just below the clutch. Pour the new oil in the primary chain inspection hole of the primary. Good Luck ...
Question about 2001 XL 1200 C Sportster Custom
...primary condensate drain line. The plastic heat exchanger cover has a number of drain ports to accommodate any configuration or installation, this means that the drain lines need to be connected ...
Question about 2001 XL 1200 C Sportster Custom
...primary drain plug is right below the center of this cover and it is a 5/8 inch hex head with a 1/4 inch Allen socket in the middle of the plug head also. You fill the primary through this cover ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions