drain plug of some description. It may be a draincock, or just a plug. In either case, simply open or remove it to safely drain your heater. In a pinch, you could also disconnect the water connections
plug instead of a drain **** and you can remove the brass plug. Or the best way i think is to unhook both unions for the inlet and outlet on the heater, use a shop vac on blow, and blow the water out.
...drain plugs in your heater ... use a shop vac (without the filter in it) to blow and then **** out any remaining water. hopefully, your pressure and suction pipes lead away and down from the boiler. ...
...drain plug if anything. Other than the drain you'll need to remove the pressure switch from its feeder tube and leave it hanging by its wires for the winter. Be sure the heater is level or tilted ...
Question about 250kbtu Ng Pool Heater - Inground
drain plug on the bottom of the header. This is common on most of Hayward's in-ground pool heaters. Since you did not give your model Number, I can't say 100%. You can also check Hayward's website for
Question about H Series Millivolt 250,000 Btu Pool Heater H2501
my hayward pool heater is leaking through the drain plug use Teflon tape or use a oring
pool heater my hayward h series pool heater is leaking thruogh the drain plug. Tried turning, tighten, remove and replace, still leaks alot. use Teflon tape or add a oring
H400 drain plug leaking The drain is leaking,does it have an o-ring use Teflon tape if no oring
Question about 250kbtu Ng Pool Heater - Inground
...drain plug on Hayward H series heater ? i want to drain the heater for the freezing weather - where is the drain plug located for the Hayward H series pool heater. There should be two. Remove the ...
Question about H Series Electronic Ignition 250,000 Btu Pool Heater H250ped2
how do I drain an h250fdn heater There is a drain plug on the inlet/outlet header.
Usually answered in minutes!
774 Questions
131 Questions
104 Questions
113 Questions
87 Questions