Questions & Answers for: drain gas pressure washer

...gas. Still surges? I have a pressure washer that surges whenever I press on the wand. The pressure is on for about 2-3 seconds and then it dies down like a water hose pressure for the same amount of ...

...Gas Pressure Washer Model DPD3100 is leaking and losing presure from what seems like the power sprayer. How do I fix this? Hi Just try the following steps Inspect the water supply connections Inspect ...

...leaks and upon starting the engine raw gas blows out the exhaust. Carb float valve sticking and draining gas into intake manifold? Get the leak ...

...the fuel lines from the carb. so that the carb will drain? if not you need to get the water out of the carb. the put some rubbing alcohol in the new gas and this should get rid of any residual ...

how do I fix a bad gas problem If the gas is bad, The gas bowl needs to be removed and drained, it holds gas ready for the carb. disconnect the gas tube going into the bottom or bottom side of the gas

pressure washer sat for one year with gas and it wont start i added fresh gas and tried starting fluid it starts for a couple sec and shuts off...What should i do? I hate to tell you but the carb will

...drain ****, with a hose attached so it doesn't get gas all over everything.  The reason to do this is to drain condensate once in a while.  See if you can find a small drain valve and ...

...Gas Pressure Washer? There is drain plug, surprisingly. You basically have to tip the washer over to the side opposite of the exhaust. I like to take the wheel off first. It is much easier this way. ...

...batch of gas. You would need to drain the gas from tank and reservoir then put new gas in it. Water could be in it the filling station could of just got new gas and your gas could of been ...

...for about another 10 seconds and cuts off. It will restart fine the same way after about 5 seconds. Drained and replaced the year old gas and removed and checked the carb bowl no water. Oil was ...