Question about MFC 7420 All-In-One Laser Printer
I can't find the back door sensor on Brother MFC-7420 My printer, a Brother MFC-7420, had a paper jam, which was completely cleared, and now I can't get rid of the "back door open" message. I know ...
...can disable? My email address is [email protected] Regards Fred Pettit look for switch where the doc door closes and insert a piece of paper to trigger it, message should clear, adjust switch. NO no ...
Back door wont close I have a Brother Copier MFC-7820N and it keeps telling me the back door is open - I have cleaned, shut/open, removed everything I can think of and the message will not go away! ...
Question about IntelliFax-2820 Laser Fax
error message reads: "close back door" when it is already closed The unit is only six months old and this is the first problem. Tech support was nonexistent as was troubleshooting. The back door is ...
Question about Multi-Function Center MFC-240C All-In-One InkJet Printer
Have a brother MFC 7420 multi function Machine. Keep getting signal on screen stating ''Back Door Open'' it is not have cleaned, everything suggested still same. can you help ? The back door sensor is
Question about Multi-Function Center MFC-240C All-In-One InkJet Printer
...this mean? i'm using DCP-195C brother printer?how to fix it? This could be that; The Ink cartridge door is open The Ink cartridge door sensor is faulty/bad Something is block the ink cartridge door ...
where is the back door sensor located open your rear door and you'll see that a black guide will open also. on the black guide you'll see a black lever sticking up. thats the sensor lever. if ...
Question about MFC-8510DN Monochrome Laser All-in-One Printer - with Duplex P
...door sensors locations? Get "open door" in the print window title bar. Can't figure out where more than one door sensor is to clear it. Front and top give cover open on the printer window when ...
Question about MFC-8510DN Monochrome Laser All-in-One Printer - with Duplex P
...for this is because the magenta cartridge has a clip on top of it that goes into the cartridge door sensor. The clip needs to push the sensor in so the printer is able to function with the ...
pls close cover press on the top right hand corner of the front door and see if it goes away. these doors start wearing at the pivot point inside the door at the bottom and hangs down so it does not ...
Usually answered in minutes!
1,135 Questions
1,072 Questions
1,012 Questions
767 Questions
733 Questions