Questions & Answers for: Hayward doesnt turn on

turn over. Any suggestions? The pump needs to be primed by adding water to the basket.If it still doesnt start it might need the a rebuild which usually involves replacing the bearings(cost about $150

If you notice one, try stretching the hose on a flat surface in the sun for several hours. If this doesnt work, you will probably have to replace the hose

...on flame (DC millivolt setting on multimeter). Put one probe on ground other on sensor lead. If it doesnt have voltage this is bad. If you do, its possible your board is

...doesnt turn at all. as a matter of fact it goes into the shallow end and stays in one place. yes, the feet continue to move its like its spinning her wheels...mike With these automatic pool cleaners, ...

...turn it by hand. So I removed the blower from the heater and sprayed some wd40 onto the shaft (underside and above). From that point it seemed to spin freely so I put it all back together, and no the ...

...doesnt spin impellor was stuck or froze so took it apart and got it to turn with some force, stil doesnt move freely. put it back together and motor just humms and impellor doesnt turn. need new ...

...turn The Viper moves very slowly. It will climb halfway up a wall and get stuck. Doesnt turn. Suction is great, just wont move around check water flow to unit if ok take apart check hoses and ...

...treat the O ring (not vaseline). while applying lube, look for checks or cracks in the O ring. it doesnt take much for a leak. when you are putting unit together, make sure the air release valve is ...

How to reset raypac pump that just stopped working try turning the shaft on the back of motor then turn on if this doesnt work you need a new one

...doesnt work in spa mode but works in pool mode.. does the pool tstat have a lower temp limit? when in tstat mode with pool only hooked up turn heater all the way up to 104 keep on pool the control ...