Question about Toyota 4Runner
i replaced the head on my engine. I'm getting water in the crank shaft. what would cause this? i replaced the head on my 87 toyota 4 runner 22r engine. since then, i have been getting water in the ...
Overheating and water mixed in with oil 1994 four wheel drive Toyota Pickup 22RE I think there is a blown head gasket i replaced the head on my toyota 4 runner. Since then I have been getting water in
...for a hole or leak in your air intake tube first, then do a basic tune up...plugs/rotor/air filter/dizzy cap (if needed) and inspect vacuum lines for cracks......these would be the most common
i have a 30lite kzte diesel and had to replace the cylinder head for the second time .The heads tens to crack on the no4 piston you need to get a mechanic that knows what he is doing. The head has to ...
1994 4runner, six cyl. putting rebuilt heads on, toyota head gaskets, new head bolts "tvs 10.9". Torqued bolts in pattern to 33 foot pounds. another 1/4 turn in the pattern. and into my next and final
...notice 1.5 amps coming out coil lead and coil terminal with key switched off. white powder in dizzy cap where coil lead arcing. pulled plug apart to coil so no power but still drained. could it ...
1989 v6 camry engine missfire i have a 1989 v6 camry engine running on 5 cylinders. As i accelerate under load it is very prominant. Plugs are good, compression is good, leads good, dissy cap good, ...
radiator ,resivor,and heater core full of grey like milk shake .removed the heads appears to me not blown .heads checked out fine so what cause gunk in these 3 locations but also no white smoke .oil ...
where is located the cam pisition sensor PO340 at the end of the cam shaft. if car has DIZZY (a distributor) it's in the base of the Dizzy. which engine, of the many.?????????????? http://en.wikipedia
Usually answered in minutes!
676 Questions
427 Questions
430 Questions
361 Questions
348 Questions
