...Distributor Cap Inspect|Replace The distributor cap should be removed for visual inspection. Check the cap for: Inspect the distributor cap and rotor. Courtesy of American Honda Motor Co., Inc. ...
...cap. Distributor holddown washers and nuts and torque to 9 ft. lbs (13 Nm) EGR tube. Air inlet tube, resonator and air cleaner cover. Hose clamp at throttle body. PCV make-up air hose from air inlet ...
...distributor cap on 5.2 l v8. I need to remove my distributor cap and can't see how it is fastened behind the engine. Are there snaps, bolts (with or without screw slots)? If bolts what size are they? ...
...distributor cap and remove the cap. Remove the bolt securing the distributor. Disconnect the crank angle sensor connector and remove the distributor. Install the distributor, making sure the rotor is ...
distributor cap. Label and disconnect the wires from the cap. On some engines it will be necessary to use a flat bladed tool to lift up the lock claw and disconnect the holder from the cap. Fig. 5: On
...distributor cap.mark location distributor cap.number tag plug wires on the distributor cap so you can remove plug wires on distributor cap so you can replace cap and rotor and put wires back on the ...
...distributor cap is to be replaced, mark the ignition wires for identification and remove them from the distributor cap.Remove any components necessary to access the distributor cap.Completely loosen ...
Question about 1985 K2500
...distributor cap where is the ignition coil located. 350 motor 4bbL has a distributor cap looking for location of coil in this vechile It should be located in the top of the distributor cap. Hopefully ...
Question about 1985 K2500
...located on 2003 Ford Focus no such thing---- their are parts called coolant cap [reservoir tank ] coolant [radiator ] cap --distributor cap Are you looking for the coolant cap or the distributor
distributor cap is not accesable Window on distributor cap is to set dwell, not timing. You can set dwell by removing the distributor cap and gapping the points to specification, then verifying with a
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions