Questions & Answers for: Mazda B2200 distributor

will not fire quit running,no fire to plugs replaced all parts in distributor,new coil and coil wire check the ignition switch and wiring ..did you replace the distributor cap how about plug wires ...

...on mazda 1987 pickup truk motor is a 2200 get number one piston up on top dead centre, remove the distributor cap and check the rotor to see if it is pointing to the number one post on the ...

...rotors n cap could this be the problem n how do i fix it The only way that oil would get into the distributor is if the o-ring at the base of the distributor is damaged. To check this, do the ...

...over again.A co-worker said its either the fuel pump or spark plugs and also suggested I change my distributor cap.Could it possibly be my fuel line?Any suggestions would be appreciated.Thx I would ...

on sunny days it starts , on rainey day it just turnsoveer but will not start It sounds like you're getting moisture in the distributor cap. Try replacing it.

1988 mazda b2200 gets spark from the coil but not the distributor Remove the distributor cap, crank the engine is the distributor rotor turning? Then check the timing belt.

wont start..no spark computer problem? many things will cause no spark bad distributor cap or rotor.bad plug wires.ignition timing to far advanced cause by loose distributor.could have faulty ignition

can oil pump shaft be ajusted on 2.2 mazda 1987 eng noise at distributor replaced the distributor the noise still there Change the Oil pump the pump inner bushings are probably worn.

... There are no signs of major engine damage, short of a compression check. Crankshaft, camshaft, and distributor alignment look good, but still only back-fires if anything at all. indicates valve ...

...If you have 12 volts ( or 7.5volts) to one side of the coil and nothing on the lead to the distributor then I would think that the coil is burnt out or faulty. If you have the voltage