...button to display the date, then press the lower left button. If now all the weekdays are turned off, the hourly signal is turned off too. If the weekdays are turned on by this operation, the signal ...
display. Repressing the "B" button will put the hands back at the correct time. hope this helps. Found the manual! Here's the link: http://www.bulova.com/dynamic_repository/instructions/581.pdf i just
...button shows a number and a date... There were no instructions in the box. Any help would be GLADLY appreciated. Hi, try holding down one of the buttons until the display flashes, then use the other ...
...button it will display the split time for 10 seconds. 4. When the chronograph is stopped press the lower left button to reset back to zero. SET THE TIME ZONE 1. Setting the time zones allows you to ...
...button three times until the digital display rightmost two figures for seconds flash. Press the lower right button labeled RESET until the item you want to change is flashing. Pressing RESET cycles ...
...button the display should change e.g. the hours flashes; to change the time try the buttons on the right side. Keep pressing the mode button to reach the location setting function. I expect that you ...
button until seconds display starts flashing. 3) Press "ST./STOP" button to change selected entry. 4) Press "Mode" button to change from seconds>minutes>hours>date>month>day of the week
...99357 mcdevito75 here, the 2 buttons you need are the MODE and SET buttons, press Mode and see display flashing, now press SET to cahnge any of the settings, Hour, minute etc. press mode after ...
...the setting menu. Keep pressing the mode button and you should arrive at a point where the screen displays the hour that the watch is at present set at. Experiment with the buttons on the right to ...
Usually answered in minutes!
756 Questions
28 Questions
21 Questions
18 Questions
20 Questions