Questions & Answers for: disk initialized error hp printer

...error 8388D4 EIO devise 3 disk not funtional high this problem continues to plage me (my printer) are there any fixes yet?????????? Try the following steps to reinitialize the HDD: 1 Turn the printer ...

disk error. Always try initializing the hard disk before replacing it. NOTE Before performing a hard-disk initialization, print a menu map and a configuration page (see Menu map and Configuration page

...Disk Drive) Error. Corrective Action: Try the following: n Switch the Printer OFF and ON again and wait for the initialization. n If the Error code continues to appear, switch the Printer OFF. Remove ...

...disk which was running forhours without result. Please advice what can be done to get the printer runningagain as we can not access the printer with the error message prevailing. Thanks for your ...

error code 49.4401 Disk Init Procedure 1. Turn the printer off, then on 2. When the memory count starts on the control Panel, press and hold the Menu button until all 3 lights on the control panel are

...disk error. Always try initializing the hard disk before replacing it. 1. Turn the printer on.  2. As the printer performs its power-on sequence, press and hold the Menu button until all three ...

...error? all you have to do is initialize hard disk even if you do not have one. Just turn off the printer. Turn the printer back on and when the memory starts to count hold down the menu key until all ...

...disk not initialized .how to solve. thank you. Turn off printer Press and hold PAUSE/RESUME(START on MFP) Turn on printer Keep holding the PAUSE/RESUME or START until all 3 error lights light Release ...

...Disk Error and then I press Continue then it finishes with Error 090014 00000001? Anyone have any ideas? It has been sitting for about 2 years now. Replace the hard disk on the printer. If this ...

...Disk Drive. If the Error Code disappeared after removing the EIO Card, then switch the Printer OFF and reinstall the EIO Card, making sure that the two installation screws are completely tightened. ...