Question about Minimax Ch 250,000 Btu Natural Gas Pool Heater Millivolt Ignition
BiAnnual maint of Pentair Minimax NT Low NOx Series Pool Heater We live in the southern california desert and have had recent problems with our heater. The technician says that the unit needs to be ...
Question about Minimax Ch 250,000 Btu Natural Gas Pool Heater Millivolt Ignition
I live in the socal desert and have a Pentair Minimax NT spa heater. We have had it fail twice in the past 2 months. The tech says that we should have it disassembled and cleaned (desooted) every 2 ...
low water flow Why does this pump backwash like crazy and won't run water thru the filter very well? 1. If your filter hasn't been backwashed, that's a good place to start. 2. If you haven't done a ...
Question about One - Speed 1hp 115v Dynamo Pump without Cord
need to disassemble pentair dynamo pump to replace shaft seals, can't get impeller off the motor shaft; it appears to be pressed in place; need suggestion for removal technique. Remove the cover from ...
Question about STARITE PUMP HOUSING / TANK BODY
...for about 5 seconds then cut off. What could be wrong? Your pump motor or impeller is seized. Disassemble the pump housing and check the impeller to see if it spins freely. If not then check
...the noise in this manner. My money is on the impeller. You will need to replace the seals when you disassemble the pump motor from the pump housing. I found a dime in the impeller recently ...it
Pool shut off, went to investigate and found that the pool motor and flipped a breaker, reset and when I tried to turn motor on again, the motor just hummed but didn't turn over. The pump needs to
where is the ignitor for mini max model 250 located? i disassembled the unit and bought one from a pool supply place that they said was the one i needed, but i can't for the life of me see it.
Question about Push Pull Valve 7-1/2 in. Centerline, PVC Slide Valve Slip Almond - 263064
263064 valve problems How do I disassemble the valve main plunger? http://www.pentairpool.com/pdfs/270163.C-TwoPositionSlideValve.pdfThis is the manual for your valve. Maintenance section tells how to
Question about Push Pull Valve 7-1/2 in. Centerline, PVC Slide Valve Slip Almond - 263064
2 speed 2hp pentair motor disassembly need details on disassembly of the motor down to the bearings. don't need motor wire disassembly dont bother replacing bearings nobody does replace whole motor ...
Usually answered in minutes!
337 Questions
104 Questions
92 Questions