Questions & Answers for: direct tv dvr blue light

tv thru my pvr i put volume at +18.0 and it's not loud enough...... Depending on what type of remote you have the DVR volume may need to be turned up. On the DVR remote hold the cable button until the

...TV or DVR. Unplug your TV from the DVR and connect it directly to the wall outlet. Then connect a TV antenna, or a small thin wire, to the F connector on the back of the TV (this is the threaded ...

direct tv code I need a code for Direct tv hd 22 dvr to use on my Emerson jumbo remote control Try to find out the code of the device by pressing code search till light turns on, press device, press ...

...blank and light is blinking. The blue power lights are not on. Unplug the DVR for about 20 minutes and then plug it back in. If that doesn't work its probably time to contact DTV for a

Direct TV DVR record light on, but it won't do anything The Direct TV DVR yellow record light stays on all the time, but I can't get the receiver to work. I have hit the red button several times and ...

...TV with a DVR attached. I have no picture, no sound. When I push the button to turn the set on, it sounds like it is turning on but just the red light on the button just flashes. The red light will ...

...direct tv with DVR box. Took down last night tried with other system using red, white, yellow connectors. After moving and after worked. Put back up and worked. Turned off for the night, then same ...

Direct TV less than 3 weeks since it has been installed was working fine. Then one morning when i went to turn it on there were no flashing blue lights on the front of the DVR plus i have no controlls

direct tv remote has a slide at top for TV and Direct TV have a Toshiba 22AV600U need TV code we dont do codes Slide to far left direct TV press menu button scroll down blue highlight settings& ...

...mode, just stuck in a loop. you need to reset your DVR. Push the center button in and hold it until it turns off and then turns on again. Let your tv reset it will take a few minutes just be