Question about RHFE-431FAIII 16,700 BTU Direct Vent Furnace Energy Saver Heater - Natural Gas
The Rinnai on demand water heater we just installed keeps shutting off then leaving a error message #10 on the display. vent blockage, bad fan, wrong DIP switch setting
Question about RHFE-431FAIII 16,700 BTU Direct Vent Furnace Energy Saver Heater - Natural Gas
Dip switch settings for Rinnai V1200 & V1500 Does anyone know the dip switch settings for adjusting the temperature on Rinnai V1200 and V1500 water heaters? curios to find out if you had any help ...
Question about RHFE-431FAIII 16,700 BTU Direct Vent Furnace Energy Saver Heater - Natural Gas
...PDF's include schematics for all dip switches Please note: you'll need to get the pdf that corresponds with the correct model you have. thank you for using fixya,rate my answer ...
Question about RHFE-1004FA 38,400 BTU Energy Saver Ductless Heater - LP Gas
...make sure you adjust the DIP switches to the original settings on the new control board. If you live in the states, I can sell you a new board for $125.00. Contact me at "the_rinnai-guy
Question about RHFE-1004FA 38,400 BTU Energy Saver Ductless Heater - LP Gas
Check all vent components for proper connections. Ensure vent length is within limits. Ensure condensation collar was installed correctly. Verify dip switches are set properly. Check fan for blockage
were are the located ? Dip switches are located on the circuit board.These switches are for changing temperature and altitude etc, and depending on brand and model, the switches settings are different
...are per instructions. Also make sure that nothing blocks the venting system or fan, and that dip switch and condensation collar are set properly. Good luck, ...
Question about R98LSiN
...and gas valve must match, threads are regular instead of reverse, dip switches probably have to be changed since combustion of NG is not as hot. Maybe different sensors. Pressures are lower with
Question about RC80i Tankless Water Heater 8.0 GPM 157,000 BTU
...changed to accommodate different gas. Different gas control valve needed. In some cases there are dip switch changes for type of gas and altitude above sea level ... the higher the elevation, the ...
Question about RL94i Tankless Water Heater
...water heaters allows changeover by installing new chipboard or changing dip switches... some do not. Propane burns much hotter with higher pressure than natural gas Gene Water Heater Timers Save ...
Usually answered in minutes!
192 Questions
46 Questions