How to test a diode I want to see if the diode is good for my GE SPACEMAKER XL1800 is good. To test a diode, first remove it, then use a test meter with a diode check facility. Test component first ...
Question about Spacemaker JVM1640SJ Microwave Oven
My GE jvm230 blows fuse when the start key is pressed. Refused and all is well until start key is pressed again and the fuse blows. I think my HV cap. is shorted. The HV capaciator isreading less than
Every thing works fine but no heat. Unit was installed in 2005 and looks it working fine but in the last couple of days it does not warm or heat the food. Did you change the diode as well, if not you ...
GE Spacemaker diode connection I have a GE Spacemaker microwave that stopped heating. I have checked the magnetron and the diode, the magnetron looks like it is good, but the diode checks open in both
Question about Spacemaker JVM1640SJ Microwave Oven
GE Spacemaker JVM1430BDC01 appears to be working but is not heating food or drink either the h.v. capacitor or h.v. diode are open,if they short the internal fi=use blows,remove the cover and ...
Question about Profile Spacemaker Over-the-Range Microwave
...anode to forward bias the diode. The meter should read a very low resistance - approaching 0 ohms. Diodes should conduct in one direction only - and the other is should look "open" If it conducts or ...
...it is shorted or open, a defective diode will most likely show some sign of defect. Defective diodes will usually emit an electrical burning smell, signifying its defectiveness. Also, it may ...
...it is shorted or open, a defective diode will most likely show some sign of defect. Defective diodes will usually emit an electrical burning smell, signifying its defectiveness. Also, it may ...
Question about Spacemaker JVM1640SJ Microwave Oven
...it is shorted or open, a defective diode will most likely show some sign of defect. Defective diodes will usually emit an electrical burning smell, signifying its defectiveness. Also, it may ...
...If you suspect it, replacing it would be much cheaper. A typical DVM will not do the job. But diodes usually are not the first part to fail; check the
Usually answered in minutes!
3,405 Questions
257 Questions
57 Questions
46 Questions
27 Questions