Question about Sport 1000 Folding Treadmill PFTL91205 - !
...vs display board .4) Tight the connector from display board vs main controller board.5) Adjust the Reed switch +speed sensor(touch the magnet with another face in the motor).See the block
Question about 680 LT Treadmill
diagram. If after adjustment the problem persist. You must Test or measure the voltage for +5vdc to I.C.( EPROM, ROM, etc) , coming up from the Lower Board( Main Controller Motor Board).Re-connect the
Question about 650 Crosstrainer Treadmill
board,5)aTTACHED THE diagram for sensor reed switch adjusted by 1/8"6) Test the main motor controller board for 115 Vca, +5vdc FOR OUTPUT GOING TO DISPLAY BOARD.7) tEST THE transformer see the tips.8)
...if coming to motor controller board and then display board.Attached the block diagram for better understanding and diagnostic foryourself.sincerely. Merry Christmas.ernesto cuadramanagua,
...diagram. adjust the reed switch.2) Tight the flexible cord or ribbon cable from key panel.3) Tight the connector from display board to main motor board or lower board.4) See if you display board has ...
Question about 680 LT Treadmill
...diagram attached. 2) Tight the ribbon cables from keypanel 3) Tight the connector from display board vs main motor board.Run the software calibration for easy diagnose and troubleshooting.See my ...
...diagram attached 1/8-1/4". 2) Tight the ribbon cable from keypanel (display board) 3) Tight the connector from display board vs main motor board.Run the software calibration for reasy diagnose and ...
Question about 680 LT Treadmill
...diagram attached, clean, and tigh the wires connector very well.3) Measure the input voltage motor, if there are the motor need repair4) Measure the output voltage board, for input voltage motor, if ...
...diagram attached. 2) Tight very well the ribbon cable for keypad 3) tight the upper connector board vs lower connector board 4) Replace batteries with FULL charges, the same mark, and the same ...
...diagram),of a proform V650 treadmill. Treadmill powers up. Display and keys seem to work. Incline motor works. Pressing start shows speed on display,but main motor does not turn. From quick ...
Usually answered in minutes!
188 Questions
112 Questions
99 Questions
96 Questions
64 Questions