Question about DW056 18 Volt Cordless Impact Driver - 1/4" Drive Hex Shank (Battery Charger and Case Not Included) - Tool Only
...just place the small bit directly into the driver without needing to use the 'extension'. check the chuck it migth not be closing ,spray some lubricant or you may have to change the ...
Question about 18 Volt Compact Drill Kit
...impact it out with the slide puller. Or you could take the bit holder apart. There is a retaining ring that holds it all together right on top. Pull that off and a washer, spring and the collar will ...
Question about DW056 18 Volt Cordless Impact Driver - 1/4" Drive Hex Shank (Battery Charger and Case Not Included) - Tool Only
...driver bit, after a two or three uses, the drill bit, or screw bit comes loose. Every time I tighten it it loosens again. On this particular tool, you can't really tighten the bit in the anvil like a ...
Question about DCF885C2 20-Volt MAX Lithium Ion 1/4-Inch 1.5 Ah Impact Driver Kit
...impact driver more often than not the bit falls out of the driver. sometimes it locks into place. have used different bits so i fell sure that is not the problem. There is a small spring at the back ...
Question about DCF885C2 20-Volt MAX Lithium Ion 1/4-Inch 1.5 Ah Impact Driver Kit
DeWalt 20 V impact. Driver ejects occasionally. Locks in correctly to start then after limited use, bit holder falls out. These are known for the spring in the nose (#12) to fail. Using an o-ring pick
Usually answered in minutes!
227 Questions
165 Questions
160 Questions
104 Questions