Questions & Answers for: depress washer spring clip

Ad

Question about LSR9434PT Top Load Washer

1 Answer

...washer to get at these springs. at each front corner there is a bent spring clip which must be depressed. once you depress this clip the top moves upward. use a thin putty knife to depress the clip. ...

Ad

Question about LSR9434PT Top Load Washer

1 Answer

washer 80 series. how do you replace it Good day, 1. There are 2 screws. one on each bottom corner of the control console. The may be hidden by plastic end caps that have to be uncliped. Remove screws

Ad

Question about WHDSR316G Top Load Washer

1 Answer

Washer won't spin WHDSR316G1WW will not spin. All belts attached. It could be the door switch assembly. By inserting a 1/2 inch paint scraper between the front panel and the top about one inch from ...

Question about PAV2300 Top Load Washer

1 Answer

washer overfilling on oversize setting Is it the fill setting switch? Most likely it is the clear rubber hose that connects to that switch. IF you pop the top up you can llok and make sure it has not ...

Question about Ultimate Care II LSQ9549L Top Load Washer

1 Answer

...washer) on the left and right sides that go through the end-caps. The screws are either in the front side of the end-caps or in the back side. They need to be removed to allow the panel to be slid ...

Question about Elite Oasis 27052 Top Load Washer

1 Answer

...washer...most important and safety first** 1) this is best done with a puddy knife or something similar to depress the clips on both sides, i.e. (these tops are quiet heavy and the lid has heavy ...

Question about 2009 9-7X

1 Answer

...washer with the curved edges of the wave spring parallel to the tabs on the lock cylinder shaft. Important: Use needle-nose pliers to slightly squeeze the C-clip back into shape. Make sure the clip ...

Question about 2009 9-7X

1 Answer

...washer with the curved edges of the wave spring parallel to the tabs on the lock cylinder shaft. Important: Use needle-nose pliers to slightly squeeze the C-clip back into shape. Make sure the clip ...

...Washer is shredding our clothes - sounds like a machine gun when at end of spin cycle. Yes I do know. First pop the console off with a putty knief. Run it under the ends on each side and depress the ...

Question about 2009 9-7X

1 Answer

...washer of this type is a putty knife. There are two spring clips located about 4.5 inches in from the corners that you depress with the putty knife through the seam in the front. The trick is that ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8221 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1482 Answers

Brad Brown

Level 3 Expert

18666 Answers

Are you a Washing Machines Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...