Questions & Answers for: dehumidifier sensor reads low

...dehumidifier runs all day but there is only a little water being produced. We have humidity set at 35%, and the actual readings are much higher. This is only a year or so old. The last machine worked ...

reads low humidity even though its high Hello, First, make sure the reservoir is empty. If you plug the unit in and see a green power light, but the unit won't run, make sure the reservoir is properly

...humidity for the sensor to read. But, at 35% there is. I'd say, your dehumidifier is working as it should. FYI - there is no adjustments to change the factory settings. Hope this helped you,

...Low Temp Unit). This applies mainly to where the air temperature at floor level is colder than at shoulder level in basement applications . Raising the unit up off the floor, onto a sturdy table, ...

reads the humidity as low and so never turns on. Can I just replace the hemostat? I think you are referring to a humidistat, not that thing the the doctors use to clamp off a vein to stop the bleeding

...Low temp models, will respond that way. Raising the unit up of the floor on to a sturdy table, counter top etc, that can handle the weight of the unit, plus a full bucket of water, will generally ...

...reads 40% all the time. There are 5 basic, but solvable reason for what you described. Please pay particular attention to numbers 1 & 2. 1. The humidity extraction level is set to HIGH. Lower it ...

dehumidifier no longer dehumidifies unless I set the humidistat to the lowest, constant run setting--then the compressor kicks on. The humidity reading says 14% which I know to be erroneous. I suspect

...Low Temp Unit). This applies mainly to where the air temperature at floor level is colder than at shoulder level in basement applications. Raising the unit up off the floor, onto a sturdy table, ...

...dehumidifier. There could be several reasons why the humidity reading on the digital control is not accurate. Here are a few things you can try: Calibrate the hygrometer: The first thing to do is to ...