Questions & Answers for: GMC Jimmy deep penetrating

...drive for awhile and stays on. Do you know what caused it to do that? Started after I was stuck in deep snow and used 4 wheel to get out.. likely a abs sensor at the ...

...OIL PAN I AM LOOKING FOR INFO ON HOW TO TELL IF MY 2003 JIMMY 4.3 VORTEC 4X4 HAS A SHALLOW OR DEEP TRANSMISSION OIL PAN CAN ANYBODY HELP ME WITH THIS the depth of the tranny pan isn't really ...

...penetrating oil. You can use WD-40, PB Blaster, Deep Creep, or something similar. After you have sprayed all of the nuts/bolts, let the penetrating oil soak in for about 10 minutes. Now remove the ...

keeps blowing rubber elbow atached to emissions exhaust check valve The check valve is not "checking". Check valve is the commonly used term to describe a "one-way" valve - a valve that lets the ...

that the OS located closes to the exhaust, after the cat converter, before the muffler is bad. Down deep it could the wiring or connector. Let me know if I could help any more... Good Luck..

location of oriface tube It is located in the inlet tube to the AC evaporator core, the tube in deep inside that inlet, the small AC hose (called the liquid line) from the compreessor is what is ...

...It is fairly straight forward and will require a basic set of tools (mostly a 10mm socket short and deep, a couple extensions, a swivel, and a ratchet). It should take you about an hour to remove the ...

how to change idle arm on 1987 fifth avenue It takes a 9/16 or 5/8 deep well socket with a long extention to reach thru the holes in the frame. Remove the 2 bolts inside the frame. It should come ...

The emergency brake pedal on my 01 gmc jimmy does not hold at all. We have replaced the back brakes & can see hat when the emergency brake is pushed down it engages on that cable back there.But ...

how do i replace the upper control arm bushing on my 2000 GMC 4wd jimmy blazer iv got it off just need to put the new one back on what is the easiest way of doing this? Use a C clamp type bushing tool