...the same sub in another system and was dynamic. i cant increase the sub vol. control panel show 0db but does not go up or down. i can adjust other speaker vol . it is only activated when dolby pro ...
...sounds, hearing the dialogue is very difficult. I moved the center channel decibel level from 0.0 dB to +12 dB and it may have made a little difference. The surround sound mode is currently 5.1 ...
...everything up and all working ok. My question is why the volume level need to be cranked up pass -50db to -40db to start hearing sound and at -13db to get good decent hearing volume (not extremely ...
...I turned back on and work fine again but did the same since was a action movie,( right about a -6.0 db) I noticed the power indicator blink a few times after that, I turned back on and work fine at ...
...dB isn't normally 'normal' volume. I wonder if the fan is a self-defeating work-around because the noise might make you want to crank it up so higher so you can hear it. Apple TV? Is it a ...
front left speaker humming and 15 db more quiet Check the driver (Cone) on the speaker - if it moves in and out freely - be gentle - then it is OK, but if its at all impeded or occasionally catches ...
...on then flash red and turn off... how do i make it stop or fix it?? In most AV receivers if the standby light flashes after turning on and you don't hear the regular click of the relay engaging ...
Question about AVR-689 7.1 Channel Home Theater AV Receiver AVR689
...remote control increase and decrease volume buttons or use the volume dial on the main system, the dB values correctly increase and decrease. What can I try to determine the problem? Check sound
manual speaker set up with a test tone for each channel. This will allow you to boost or reduce the DB level of each speaker individually. I would do this while sitting where you do while watching TV.
Question about Avr-4802R-Av Receiver-7.1 Channel
...Response 45 - 22000 Impedance 8 Ohm Recommended Amplifier Power 10 Watt, 10-150 Sensitivity 91 dB My confusion is this - I see a number of AVRs - Yamaha, Pioneer, Denon at 80W RMS (80 W/ch (8 ...
Usually answered in minutes!
135 Questions
96 Questions
101 Questions
78 Questions
82 Questions