...Data Link Connector (DLC) (Figure 3). Connect the timing light. Using the Malfunction Indicator Lamp (MIL) No special equipment hookup is required. STI is jumpered to SIG RTN at Self-Test Input (STI) ...
...Data Link Connector) .The Data Link Connector is located in the passenger compartment. It is attached to the instrument panel and accessible from the driver's seat. The DLC is rectangular in design ...
data link connector (DLC). Refer to your owner?s manual for the specific location. Tip: The OBD-I data link connector is usually located in the engine compartment near the battery or the fuse box. The
no obd signal check fuse #17 in the passenger compartment fuse box, it is the power supply for the data link connector Fuse 17 a 20A (Cigar Lighter, OBD2 Data Link Connector)
Question about 1998 Expedition
...are different procedures for accessing the data link for reading codes. The cable for one vehicle will be different to another vehicle . Check the code reading specifications to switch on the ...
...account and then logon and put in the year and make and model and look for the free repair guides. If you dont find it there, look for the link to ALL DATA on the page. ALL DATA is not free
Question about 1998 Expedition
...click on computer data lines .Then click the search buttom . one blue link will show . click on it . Pin #13 at DLC goes to the PCM . Check for an open circuit . If not open your programmer is bad
Question about 1998 Expedition
data link connector (DLC). This makes diagnosis and testing of these systems easier by allowing one scan tool to be able to diagnose and control any module on both networks from one connector. The DLC
Question about 1998 Expedition
data link connector/connection ###disconnect the battery and clean the connection on the truck and check for blown fuses related to the data link connector this of course will clear any codes you have
Question about 1998 Expedition
data link connector on a 1994 ford econoline van e-150 data link connector will not give codes, tried using scanner and and scanner shorts out, tried using jumper and no luck. I think i have a shorted
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,348 Questions
2,636 Questions