...cylinder head or block equally the dealer has said that he has not previously come across this problem with this particular engine you said oil? could it be trans fluid because of a bad radiator,if ...
...cylinder in the first place? The engine probably overheated and a head gasket failed due to excessive heat, thus allowing antifreeze to enter the cylinder (Where it is not meant to be).Blue smoke is ...
head settings volvo s40 1.6 vvt i am looking for torque setting for head bolts on a volvo s40 1.6 vvt 2000 plate start at 45 ft lbs then 65 then 85
cylinder head scimmed pressure tested an put back on, but the problem lies lower down and if you go to a garage the usual mis conception is the heads gone, but trust me its the wet liners, and most if
...cylinder head gasket is gone.the oil does not just disappear,it finds its way to the radiator,i.e. mixes with the water.unplug the rediator cap with care(when the engine is cold)and u will see some ...
...torque setting and sequence of the bolts holding the cillender head down on a volvo s40 its R REDG Go to a local library and check the Chilton manuals, sencondly just call the dealer. tell him you ...
head settings volvo 2.4 s40 torque settings head bolts Try the public library.
...was correct or you will be doing that cylinder head all over again as it will have bent all the valves in the head and that has caused your no start... do you have compression in the
cylinder head torque specs on a 2000 volvo s70 2.4 Liter you have torque cylinder head bolts in 3 steps first torque bolts 14 ft lbs then second torque all bolts to 43 ft lbs step three torque all ...
torque specs for a 99 2.4 turbo volvo head replacement 25lbs
Usually answered in minutes!
682 Questions
502 Questions
335 Questions
175 Questions
161 Questions