Questions & Answers for: cylender head

...cylender head or cylender head gasket or ileak in cooling system check oil for creamy white sludge if non then take of radiator cap start engine see if it bubbles up turn of engine and smell into the ...

...if you shift overdrive off transmission guy says transmission si fine the truck is not firing on cylenders 1 and 3 after a full tune up and intake gasket replaced (and 1,000 dollars later) truck ...

...head bolts for a 97 toyota t100? For a 4 cylender you Tighten the bolts to 29 ft. lbs. (39 Nm). In this order. For a 6 cylender 25 ft. lbs. (34 Nm). Good Luck and please rate 4 thumbs up for the free ...

...cylender is that right ? Usually, this sort of problem is a leaking valve in that cylinder. It should only be necessary to remove the one head, service the valves for that cylinder, and reinstall the ...

Gas is going to sparkplugs,2005 hyundai accent Most likely a cracked cylender wall allowing the fuel to leak into plug chamber. This is not a easy or cheep fix.You cannot fix a cracked cylender. My ...

...cylender torque specs what do the head bolts and rocker box bolts and cylender base bolts torque on a 1985 1000cc iron head Hi Anonymous, in a criss cross pattern and your torque specs are: 1. 1/4" ...

...cylender head of my 1998 jeep cherokee. i replace all the gaskets but its still leaking. what could cause this? my jeep keeps over heating. i replace all the gaskets, water pump, thermostat and water ...

cylender or is it more likley the head. I removed the intake manifold and found a creck in the shoot where the fuel goes into the center rear cylender. dont know if i should replace head gaskets while

...cylender,not buring oil Low pressure I'm assuming you mean low compression. Do a "wet test" first. If compression is still low, check your valve adjustments. tight valves will cause low compression. ...

what is the touqre spec on a cylender hear cylender heads on what