Questions & Answers for: crud washer

...washer is in use. The solenoid for the water intake is faulty. It may just have some crud stuck in it. You have two, one for hot and one for cold connected directly to the hoses on the back. You can ...

...washer to the large and extra large levels. raise top or remove front panel(can't remember which) rear corner left small hose attached to connector on tub pull and clean probably plugged up with crud ...

...off at valve Your washer water inlet valve is stuck open. Crud under the valve seat. If this is a FAV6800A or FAV9800AI have more info for if your are going to DIY the repair. Is it the hot or

...into the switch hole and look for a crisp swich closure sound. Most likely it's jammed or crudded up. ...

...crud out the washer.These screens can be carefully removed cleaned and reinstalled .The cold side is always the one to cause the problem because the hot side most of the crud has settled in the hot ...

washer just surged on and off and I would get a tiny spray from the gun each time it surged. In other words it would do nothing. Please help... very frustrated. Thanks Sounds like the problem could be

...What can cure this? Clean any filters in the water supply line. Clean the tips in CLR to remove any crud buildup. If these action don't fix the problem, your pump seals have worn out. A VERY common ...

...crud came loose but it still will not move. did the washer cause the flood? you could have got water into the motor if it was above a few inches deep. do you hear the motor working, and no agitator ...

...very near to the main washer pump which is activated electrically. This valve will most likely be crudded up as it gets used the least. Trace the pump lines to this valve, disconnect the output

...washer..appears to be dirt, leaves..etc Hello, Suzanne - So someone, whose clothes are washed in your machine, picks up "crud" on his or her clothes. (My dad used to collect "crud" in his pants cuffs ...