Questions & Answers for: cross joint

...joint pin through the cross member is in a tight location, is tightly wedged into the cross member, and requires a special v-shaped puller to remove the pin from the cross member. If you don't have ...

...joint on the handle of our silver cross linear freeway is broken.having trouble obtaining spare part. hi olyoctus1. i have here a link for the silver cross. i've read spare parts are available from ...

...add strength to the cross. Bring the old joint with you when buying new ones as often there are two different cap and cross sizes. Good luck. Once you get past the first one the remainder are

...cross part of the old joint to force the cup out on opposite side. Repeat on all the cups, once you have the cups out clean all the rust and scale from the shaft bores. When you go to install the ...

...JOINT REPAIR KIT WILL CONTAIN A NEW CROSS - SEALS - BEARINGS - CAPS AND SNAP RINGS.INSPECT THE BEARING CAP BORES IN THE YOKES FOR WEAR AND DAMAGE.IF THE BEARING CAP BORES IN THE YOKE ARE SO WORN THAT ...

the jimmy squeaks a lot when its moving....from the underneath of the car...? check for dry/ worn u-joints. check for rust streaks at the cross of the joint check front cv joints.

...or splines in the case. The cv joint has to maintain the balls in the centre of the angle or they will bind up ( similar to a "U" joint) except that there balls instead of a cross and needle

...cross of one joint is vertical /horizontal the the cross of the other joint has to be the same or a problem comes as each loint is fighting the other in the rotation through the 90 degrees of ...

...cross trainer approx 9months old. You need to isolate the noise by listening with a stethoscope, a sonoscope or something similar to discover which is the noisy joint (are you sure it is the machine ...

What is the 3 cross am bearing? I think this is the UNIVERSAL JOINT on the drive shaft .The English refers to it as the CROSS and BEARING because it looks like a cross.