Questions & Answers for: Geo Metro cranking relay

cranks but doesn't start where would I find the ignition fuse on this car? Is it under the hood or under is the fuse box under the dashboard? It is in the fuse and relay box on the driver side fender,

i have 95 geo metro and i had to replace the fuel pump fuel pump relay a coil pack and it starts when it wants to cranks over If you mean it starts if it cranks over then its probably the starter ...

..., dist rotor position and timing marks align same as other car, no codes even after continous cranking with ignition kept on. TPS voltage from ECM 5 volts, TPS ohm's check correct. crank shaft ...

no fire(spark) on my 1.0 liter 95 geo metro, coil has proper voltage even while cranking, all fuses and relays are good all wires clean and plugged in ignition module is most likely ,but it could be ...

...relay, corrosion at wire connections, ignition switch, pick up coil, ignition control module. Is the distributor rotor turning when you crank the engine? I ask this because a broken timing belt would ...

my 94 geo metro suddenly will not start. When I turn the key there is no accsesory lights buzzer and wont crank over. I checked the main relay fuse. This happened once before and the next morning when

...relay pump and filter for fuel It sounds like a weak battery or weak coil. If it cranks slowly, it's most likely the battery. It's unlikely, but it could also be a poor or broken connection in the ...

...cranking what causes that. 1: the ECU did close the Fuel pump relay. 2: the ECU will cut fuel if there is no park (for safety) in the USA< (are yah?) the car has OBD2 test port at knees. plug in ...

...relay it apples, a ground to the low beam lamps and they both glow see red arrows below do they? or not. and battery must be 11vdc cranking minimum. a dmm meter is only $10 at walmart, and is less ...

...cranking or running. the main box is behind the battery, and is marked fuel; pump relay. do not hot wire it or risk blowing the ECU to H3LL the fuse must be good too, to the relay. the ECU controls ...