Questions & Answers for: Jeep Grand Cherokee crank sensors

Question about 2000 Grand Cherokee

1 Answer

cranks but no spark/start 4.7 v8 G.cherokee just replaced head gasket put back together no spark/start does crank.. checked all fuses, relays,most obvious usual things anti theft???? unfortunately i ...

Ad

Question about 1996 Grand Cherokee

2 Answers

car will not start car will crank but not start. has spark, oil, collant and gas. me and my dad got it started for about a second with starter fluid you getting sparks; check the basic from fuse and ...

Ad

Have an ECU problem that has caused engine not to fire. Any suggestions? Check the crank sensor wiring first. If the crank sensor wiring is good and not frayed or broken, replace the crank sensor. The

how do i replace the crank position sensor on a 2000 jeep grand cherokee If you have the type of crank angle sensor shown in the image, then it will be located on the bell-housing towards the top of ...

Question about 2000 Grand Cherokee

1 Answer

no spark either immobilisor ,chip fallen out of key ,crank sensor defunct,or the Ecu packed up,if you change the crank sensor and see what happens then if need be make another posting ,also check the ...

...More than likely needs a crank sensor, Try cranking with the crank sensor disconnected, you should not get the dashes in the cluster. The crank sensors take out the communication system of the ...

Question about 1995 Grand Cherokee

3 Answers

where is the crank shaft position sensor on a 2002 Jeep crank shaft position sensor in the transmission bell housing, passenger side at about 11o'clock if looking from the front. take a look on the ...

Question about 2000 Grand Cherokee

1 Answer

cranks but won't start sometimes. Also has cut out while idleing in traffic and again cranks but won't start. car has new battery. From what i've seen over the years with the Chryslers ...

Question about 2001 Grand Cherokee

1 Answer

Error code P0320 what is the code Its a crank sensor code. If you have a 4.0 liter replace the crank sensor adn you should be good to go. It is possible that you may also need to replace the ...

Question about 2003 Grand Cherokee

1 Answer

crank sensor location no rpm signal / looking for crank sensor location Does it run? if so then the problem is not the crank sensor which is located above the starter motor in the tranasmission bell ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...