Questions & Answers for: Buick Rendezvous crank sensors

Location of the crankshaft sensor on a 2002 Buick rendezvous The 24X crank sensor is located behind the crank pulley on the front of the engine. The 7X crank sensor is located about in the middle of ...

where is crank sensor located Hi there:You can access the crank sensor wire going into the pcm which would probably be easier to at least backprobe the wires and monitor voltage. It is the a and b ...

sensors. One behind the crank pulley and one in the block the one in the block is on the firewall side in between the transmission and the block. There is a wiring harness for this that runs under the

...crank shaft sensor located, and is there a diagram to show where these sensors are located? Replaced the first sensor located inside behind the passenger wheel, still does not start. Where is the 2nd ...

...to the sensor that is on the firewall side between the transmission and the block? We changed the crank case sensor behind the passenger wheel, but still will not start, so looking to change the ...

What is the easiest way to get to the crankshaft sensor that is between the transmission and block to change it? We changed the crank case sensor behind the passenger wheel, but still will not start, ...

...sensors, still does not start, so where is the Cam Shaft Sensor located? Dear Jean, this looks hard but it's not,!!!!!cam sensor is located on front of motor next to water pump, it's an eazy fix ,but ...

how do i find crank shaft sensor on my 2005 Buick rendezvous ultra 3.6 liter engine? Crank shaft sensor location Could be on the bell housing gear box area or front harmonic balancer?

changed crankshaft sensor on a buick 2005 rendezvous car still want crank car wouldn't code said crankshaft sensor. changed the sensor still will not start Won't crank or wont start?

...and had no spark pulled the psp to realize i pinched a wire did i fry the pcm and does the crank sensor supply the means of spark If you can repair the wire, do this first. The Crank sensor ...