Whats A/C pressures for a 98 Cherokee? Whats the low and high side pressures for a 98 Jeep Cherokee 4.0? Doing my friends car. Thanks! Ambient 21°C 27°C 32°C 38°C 43°C ...
...at any random moment, sometimes after a day, sometimes after 10 minute, or even after a week. The crank angle sensor has been replaced with no effect. The scanner has three errors code: P0340,
...camshaft position sensor may have failed the PCM may have failed there exists an open circuit the crankshaft position sensor may have failed Possible Solutions:With a P0340 OBD-II trouble code, ...
...full. Will restart and run short while and cut off again. Error codes P-320,P-340,P-1391. check the crank sensor and the ...
changed crankshaft sensor, started fine & test drive ok. sat for 3-4 hrs & would not start check engine light on with fault code 340 That code, 340 is No camshaft signal being received by the ...
Question about 1996 Grand Cherokee
need to know how to replace the crankshaft and camshaft sensors on a 1996 jeep cherokee with a 4.0 V6 engine It has a 4.0 V6 engine we need to know where the crankshaft and camshaft sensors are ...
cranshaft position sensor where is locate at JEEP ZJ it is and you can look your self here, anytime (ign. sys. opt page 8) http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service ...
Question about 1999 Grand Cherokee
...my mercury mountaineer. It will turn over and almost start but wont I have changed the camshaft and crankshaft sensors. Tested the fuel pressure' spark' and checked the fuel pump to see if it was ...
Jeep Grand Cherokee Limited 2003 P0340,P0530,P0703 classic set of codes. my guess, they grew that large of a long time>? right? but does the engine run? and have full power, you left that key fact ...
...hits, ever use google ? why not? ill type it for u ...
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions