Question about 2000 XL 1200 C Sportster Custom
How do I remove the primary cover on a 2000 sportster 1200cc? I have a Haynes service manual and it says to loosen the primary chain adjuster lock-nut and back off the adjuster a few turns. Remove ...
Question about 2003 XL 1200 C Sportster Custom
...o ring at end of clutch into primary? Right out of the manual 1.Remove the clutch inspection cover screws and remove the cover. Note: When removing the clutch inspection cover, work carefully ...
Question about 2003 XL 1200 C Sportster Custom
The bottom part of the cover for my oil tank fell into the oil tank. Is there a way to remove the cover to get it out without removing the entire oil tank? I'm not familiar with the cover you're ...
Question about 2004 XL 1200 C Sportster Custom
...the engine does NOT have to come out of the frame. First, disconnect the battery. Drain the primary cover, remove the shifter, foot peg, loosen the primary chain adjuster under the outer cover, ...
...cover. Remove the spring and the locknut. Now, remove any footpegs or anything else that may be in the way of the removal of the outer primary. Loosen the locknut on turn the primary chain tensioner ...
...sportster custom Disconnect the positive battery cable. Drain the primaary and remove the derby cover. Take the spirng and the locknut out. Go to the bottom of the primary cover and loosen the ...
removing primary cover on 04 1200c To remove the primary cover from you Sporty, you'll have to remove the shifter and foot peg. Then loosen the locknut for the primary chain adjuster and turn the ...
Question about 2000 XL 1200 C Sportster Custom
How do you remove the oil tank cover on a 2005 Harley Sporster 1200 XL Custom? Pull on the bottom of the cover until it pops loose then lift the cover off its two top pins. May have to remove seat to ...
Question about 2006 XL 1200 C Sportster Custom
...cover. The drive belt and transmission sprocket must also be removed; there is not enough clearance to allow the removal of the switch without first removing the
...without disconnecting brake line, remove small plastic clip that holds brake line to sprocket cover, remove sprocket cover to access nut holding foot rest mount, remove mount and break pedal. ...
Usually answered in minutes!
586 Questions
351 Questions
242 Questions
159 Questions
145 Questions