Questions & Answers for: counter top

counter top. This is assuming that you have room to trim. Shimming the counter top up to raise the countertop up 1/4" to 3/8". I recommend having the legs on the dishwasher. This helps in leveling. Be

...counter top need to know how much room to leave between edge of counter top and new range top Generally, you only need enough room to be able to install. The instructions with the range top will ...

...counter top. The granite counter tops will not accept having a dishwasher attached. I need installation instructions for the dishwasher which do not include being attached to the counter top. ...

...top cover over the counter to free the counter gear. if it still wont reset the top cover will have to be removed and the counter repaired. there are no new parts available for this model Pentax so a ...

...counter weight is attached to the top of the drum and can loosen and fall to the bottom damaging the spider pulley. If the counter weight is firmly attached to the top of the washer drum and the belt ...

...counter top is 1 1/4 inches thick. cannot tighten nut to hold faucet in place A lot of the faucet manufactures have not kept up with the new counter top innovations out there so I would say you need ...

...counter top??? I'm surprised an etching solution damaged it... what was the etching solution for, glass, metal??? to be honest I would try to find a spot of the counter top somewhere that is not ...

How do you fix uneven silestone counter tops? I had silestone counter tops installed 5 years ago and now they are "spliting" at the seam. This is dangerous as it is a very rough edge and you can easil

magazine, two screws in the film chamber hold the top cover. remove leather cover on winding lever loosen screw and remove. you can then remove the complete top housing to expose the counter mechanism

...counter top, you have two options, go in through the inside of the cabinet or demo the floor. The counter top is most likely glued down. This might be a hinge issue and you wont have room to work ...