Questions & Answers for: cordless phone check line

...cordless phone is not working the vtech phone keeps saying line in use and parallel set is on. I can't get a dial tone. only a busy signal. DO you have a 2 line model? If so check and make sure the ...

...cordless phones from telephone jacks throughout the home. The "line in use" is say that you have a short on the line, or a phone off the hook. So disconnect lines, then replug 1 corded phone in to ...

...cordless phone. if you have dial tone then check the cordless phone and make sure you plug into the correct port and ensure that you have the power plugged into the wall. Also, use the same cord from ...

cordless phone I get alot of static noise which makes it difficult to hear the person on the line. I have broadband and filters on every outlet. I have tried to turn off the modem but problem is still

cordless phone unusable since DSL installed We have had a Uniden 900 MHz wall-mounted cordless phone, Model EX12960, for some years and it was working fine until we got high-speed Internet DSL service

...phone. If it rings your cordless base station is bad and you will need a new one if it does not ring then there is a problem on your phone line and you need to contact your phone company. Note, the ...

...cordless phone ME4066 has no sound One of the handset of Motorola ME4066 Trio Cordless Phone has no sound when people calls and speaks from the other side of the line... checked the manual but still ...

...cordless phone work no reception? I have managed to connect old phone but cordless ones not working. Help please The cordless phones have to be registered to the base station (the part connected to ...

...cordless phone reads "check tele line" upon plugging it in to charge for the first time! Help Just purchased new cordless and have plugged in to charge and the display says "check telephone line" I'm ...

...cordless phone model CS6919-2 saying line in use what do I need to do to corect this problem? Line in use if one of the cordless phones has not been hung up properly or the end call button has not ...