Questions & Answers for: Briggs & Stratton cord rewind

...rewind the pull cord Check out the following link that I am attaching. It should assist you in rewinding the pull cord in your mower. Hope so anyway and best wishes. ...

cord ready to install ,or have a small engine shop rewind it if you cant. some times the tab that held it breaks and you have to replace it. Where do you purchase this part. The plastic tab that holds

the pull cord is locked, can only pull out 5 inches....why? Could be motor locked up or cord caught in the rewinding mechanism. Remove top engine cover and see if cord pulls now. If not then in winder

cord has no tension on it, I can't find a reset control, is there an easy way of fixing this? You need to remove the starter cover and rewind the rope a bit. It is actually not too hard to do. And you

...rewind/tighten the flywheel or get the pull cord to retract? I have the exact same problem. I read on another site that the blowout hole in the back of the mower where the grass goes into the catcher ...

cord rewind starter. The pull cord does not rewind onto the pulley when pulled. At first I thought it was the pulley which was worn. So I replaced the pulley,(spring and rope), but the rope still does

...the cord back into the tee handle then try it again.  Most have a long rope, cord etc for maximum pull,,sometimes they go overboard on the length and it binds up on the rewind of the recoil ...

...cord housing, top half of crankcase, but cant get spring to wind back in. hoe is this done take your rope off pulley then start winding pullet by hand till ti wont wind anymore line the pulley hole ...

rewind, loading itself with new pull cord. You need about +/- 20 inches of pull cord. Replace the rubber handle on the pull cord and you are ready to mount to blower housing back on the engine. I hope

...cord rewind assembly is. Riveted. On ! Any ideas ? Usually the rivets are drilled out, the cord is replaced and pre tensioned and then re riveted to the case. Have a look here; briggs and stratton ...