Control Panel doesn't work We are not getting any error messages, however all of the lights are lit up simultaneously and make our oven useless. At random the control panel will start working as ...
...Control panel was disconnected by previous owner. I need the wiring diagram so I can connect the controller to see if the oven works. Ge sent me a copy of the diagram that is also missing from the ...
...bake nor broil work. Relay in control panel clicked several times before shutting down. Cannot find control panel. Help ! You have a bad electronic control board. No repair. It must be
...POWER FIRST lift and fold out the control panel remove the ribbon cable and remove the four screws that hold the control board . replace control panel in reverse order. Good Luck!! Have a nice
...Panel or Control by: 1. Pushing CLEAR/OFF pad. 2. Disconnecting Ribbon Cable from control and waiting at least 32 seconds to see if Code recurs If code recurs, problem is in the control. Replace ...
Question about Profile JTP18 Electric Single Oven
the panel is dead will not do anything when you push any place on the control panel No other alternative but to change the control Panel. Please contact your service provider for this to do the ...
Question about Profile JTP18 Electric Single Oven
...control panel just quit after power surge. the digital panel just quit working....light still works in oven, can't set time or turn oven on. This is unfortunate. The display is a computer you need to ...
...control panel there are 3 1/4 inch screws, one in the center and 2 on either end going straight up into the console. remove the screws and slide the control panel up then out to you. Thats how you do ...
...control panel is working. Oven was heating up when it stopped The limit switch in a Ge oven usually works or is blown. I would look at the oven sensor located at the back of the oven. It should read ...
Question about Profile JTP18 Electric Single Oven
ge profile pt916sr1ss clock is on but panel will not work the clock is on, but the panel will not work Check the fuse for the panel, if it's OK, then the control board or the panel is at fault
Usually answered in minutes!
924 Questions
608 Questions
343 Questions
293 Questions