Question about 2006 Lucerne
traction control service light, what does it pertain to and where is the traction control module located. for 2006 buick lucerne light comes on usually when a bad wheel speed sensor is detected.
turning lights quit turning lights and hazard lights quit,fuses ok The body control module may have failed. It contains logic that controls turn signal and hazard operation.
Control Module (ECM) (LD8/L37) Front left side of the engine compartment, inside the air cleaner housing. Transmission Control Module (TCM) (LD8/L37) At the left rear of the engine compartment, on the
Question about 2008 Lucerne
...control module , heater control panel , the instrument cluster . remote keyless entry , etc.. After the vehicle is shut off these modules power down , go to sleep ,sometimes they don't an drain down ...
Question about 2009 Lucerne
...control module . The power door lock system consists of the following components: • The driver door module (DDM) • The front passenger door module (FPDM) • The body control module (BCM) • The rear ...
Question about 2007 Lucerne CXS Sedan
...control seat module (CCSM). Each ventilation module contains a thermo-electric device (TED), a temperature sensor, and a blower motor. The TED and temperature sensor are mounted downstream of the ...
Question about 2008 Lucerne CXL
...control module on a 2008 Buick lucerne blower fan will not run. checked the blower control module and the main control module. I have no control voltage from the heater control What are you using to ...
Question about 2006 Lucerne
...control module (BCM) and the engine control module (ECM)/powertrain control module (PCM). The shift lock solenoid is located within the floor shift control assembly with vehicles equipped with floor ...
Question about 2009 Lucerne
...control modules involved ! Can't check with a OBD 2 code reader , need advanced scan tool . No codes , check B+ voltage and ground to the module . Power Seat Inoperative (With Memory A45) Memory Seat ...
Question about 2008 Lucerne CXL
...control module (BCM) notifying it that the ignition is in the START position. The BCM then sends a message to the engine control module (ECM) notifying it that CRANK has been requested. The ECM ...
Usually answered in minutes!
405 Questions
111 Questions
54 Questions
49 Questions
22 Questions