Questions & Answers for: my connector 3 port leaks

3. Disconnect PCM 32-pin connector "A". Check for continuity between ground and EVAP purge control solenoid valve harness connector terminal No. 2 (Red/Yellow wire). If continuity exists, repair short

...after the air cleaner housing usually a 4 wire connector. map sensor is normally located on the rear of the upper intake manifold with 1 vacuum line going to it with 3 wire connector. Hope this

...connector. Look for damage and make sure they're plugged in firmly. Also check all the fuses. Double check them if you have to. 3) Pick up an A/C pressure gauge (maybe even a cheap A/C Refill kit) 4) ...

...port, max 3 psi. make sure your gas cap is on tight. this is also part of the evap system. the evap system controls fuel fumes from the gas tank by venting them through a filter. are there any other ...

...3.3L ENGINE RELIEF FUEL PRESSURE BY INSTALLING FUEL PRESSURE GAUGE TO THE FUEL PRESSURE TEST PORT WHICH IS THE SCHRAEDER VALVE WITH CAP.ITS ON THE FUEL PRESSURE REGULATOR ASSEMBLY.USE A SHOP TOWEL ...

connector to LDP. While raising front section of support bracket, connect LDP wiring clip. Install 3 LDP mounting bolts. Join front and rear sections of two-piece support bracket by installing 3 bolts

bunch of silicone type O-Rings) careful that the brittle plastic clips of fuel injector electrical connectors dont fall off and into the intake ports of engine

connector, plug (shared it is , no worry) person 1 keys on, over and over, not starting. each key runs pump for 3 seconds. does injector leak now? if no, the ECU is bad. if put back injector plug, and

...3 With the engine running, cycle the HVAC controls through all the modes. Does the air come out of the selected outlet ducts? YES - Go to Step 18 NO - Go to Step 4 4 With the engine running, take a ...

...3: do the flash blink code jumper test 4: clean the IAC 5: find all bad vacuum hoses 6: do vacuum port smoke test using machine by same name, the DLC , jumper port DLC) may be located under the dash ...