Questions & Answers for: connecting starboard

StarBoard Fx-77 Pen does not write on the boards surface The Fx-77 board is detected by the computer and StarBoard software shows that the board is connected, When we try to write on the boards ...

how to connect a 2 bank (4 batteries) to the 3 GUEST switches. how to connect a 2 bank (4 batteries) to the 2 GUEST switches with off;1;both and 2 positions plus 1 GUEST switch with on or off for ...

vauxhall vectra keeps cutting out when slowing down idle valve or posibly your oxygen sensor you need to get it plugged in on a diagnostics ( only around £30-£40) and it will give you the ...

The starboard does not connect to the computer through the USB If you have the ability and space then recover any files that you can use the RUN option from the start menu now type in "cmd" then ENTER

I keep getting the error message 'LSAdrv - Touch Sensor Error USb touch sensor error USB (7) Reset the Controller Are you using a USB extension cable? I have found that you can use a 50' USB extension

I have a Simrad AP26 Autopilot on a 28' Center Console with "virtual Steering". The auto pilot will not hold course in Auto or Nav "go to". Have changed out the computer with no improvement. The ...

Starboard needle keeps erratic behavior, engine does not lose rpm nothing seems abnormal, usual see this when gas has water but port engine runs fine from same tank and needle steady My thought is ...

I get an error StarBoard not connected. I have a T-17sxlg. My SB is connected to my computer. How is the T-17sxlg connected?  you will need to connect both the video cable and the usb cable.

saturn-x 2ch ir helicopter won't turn on In my case (after a few crashes on Christmas morning) the bottom rotor stopped working, causing the copter to spin around on the ground uncontrolably. I ...

Testing a 1979 Johnson 9.9 with muffs before using, water comes out of the idle holes but water from the tube is very hot, spits. Is there a grommet in the head which might prevent flow of water? no ...