...plastic frame,....slightly roll the knife and the snap taps will release. Slowly work around the frame until all the tabs release. Once the inner frame is removed you will see the spring connected to ...
...snap in and out when pushed as they should. Connections that have overheated and caused plastic body of switch to melt. If after a physical inspection you don't see anything obvious use an ohm meter ...
...projections that fasten the door to the appliance when shut. The bottom hook snapped off. It is connected to and moves in tandem with the upper hook so i suspect the whole assembly would need to ...
Question about GH8155XJ Microwave Oven
wires where they push onto the switches. if any of the plastic insulators look brown you have a bad connection there and will need to replace the switch and the terminals going to it
plastic cover. When you find it, remove the cover. It is usually secured to the floor of the machine with a screw or it may just snap into place Once you see the float assembly, lift the float and let
...supposed to snap on). It won't go in. you need to remove the clear plastic piece. The instructions neglected to include this important step. Lets just say my kids heard Dad say a few new
Question about GH8155XJ Microwave Oven
...connect to.On the three terminal switch, it will be open on one set of contacts, and closed on the other, with one terminal being common to both. If you find one switch that does not function ...
Question about JE1640 Microwave Oven
...holding the entire keypad assembly. Unscrew that, and the keypad will angle forward. There are 5 connections holding it..unhook all of them (you might need to, write on a piece of paper where they ...
plastic, glassware, be careful not to ignite, melt, or snap!
-Beware, as oil and fat can ignite if overheated!
-Popcorn should only be made in the oven if it is specifically designed for it.
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions