Questions & Answers for: can t connect plastic snap Car Audio & Video

...can I connect it to face? The Face cover is snapped in, so you need to use a small flat tipped screwdriver and run it around the black and silver plastic cover, and it should snap off. Take Your

Ad

...plastic peace on trans and you will see how its connected in trans. it will look like a little piece of wire with a bend in it and the end of cable will have a hole that slips over to connect it to ...

Ad

Question about 1989 Cutlass Ciera

1 Answer

...plastic pieces you'll find two snap in ends. And on the other piece you'll find it's more of a circle that has a snap in bar across the top of the circle. The object here, is to take the one piece ...

Question about 1989 Cutlass Ciera

1 Answer

...snap, carefully pull up at the corners of the plastic engine trim covers, and the bare aluminum upper intake is under that, there is no coil pack, each cylinder has its individual own coil over the ...

Question about 2001 Grand Am SE

2 Answers

...connect unscrew plastic cap ONLY ONE WILL CONNECT TO REFRIGERATANT CAN HOSE thats your low side high side will not connect so try one to snap on fitting you will feell oily pressure at first snap but ...

...snap together. I removed screws from the bottom and could not separate the shell. I them unscrewed the metal shroud from the inside and removed it. It is a tight fit. You will see the snaps inside. I ...

Question about 2005 Avalanche

1 Answer

...clips) look for 2 rods, again 1 connects to a red clip, the other to a Green, replace the broken one, or a cheap/temporary fix is to use a plastic zip tie at the connection. Snap the bezel back

...case a cable is hanging loose. it has a black plastic snap fitting and 2 plugs.I don't know where to connect it. Great that the problem is solved. You can't close this thread. Just leave

snap in??97 Accord 4dr se, I have the door panel off on D/S because it won't open from inside, the plastic attach that is connected to the handle is broken. I h The opposite end of rod goes to the

several of the plastic tabs between the connectors in the embroidery connection (machine side) snapped off of 830. Can this unit be replaced? Check with your local dealer. Usually, plastic parts that ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...