...mixer, the EQ could be set to kill the highs. Assuming it isn, something simple like an EQ setting, probably the units will have to be serviced. I know you would already have checked the EQ on the ...
...How do you hook up a Ashley MQX 2310 EQ or a MXR Dual 2/3 Octive EQ? Thanks, BART Many of those connections REQUIRE using TRS cables (stereo style) rather than TS cables (mono style). It is ...
...Mixer L/R ===> EQ Input L/R ==> Amp Input L/R ==> Speakers L/R Using insert cables you would have a single 1/4" connector at the mixer end (inserted in to the "insert" L or R) and the other ...
...mixer. A diagram would be appreciated. Thank you! There are so many possibilities for connection it is not practical to try other than a very cursory explanation. The first thing is WHAT channels ...
...eq board all solider joint are good. any suggestions? I suspect one of the upfront IC amps has been damaged. This can happen if people power the mixer from a receptacle that is different from where ...
Question about TH-15A Active DJ Powered THUMP Speaker Stand and Cable Set TH-15ASET1
...mixer uses the XLR outputs and is powered from the same receptacle, even if you have to run an extension cord to it. This is a bi-amped speaker so there are independent amps for high and lows. With ...
...mixer control, even on the EQ portion. It may also be a bad cable is connected, or a 1/4 inch jacked input may not be grounding out when the plug is removed. You may have a bad ground on ...
...how you may wire your system. Please remember that compression, limiters and EQ device connect between the mixer and the amplifier with their prespective IN and OUT levels adjusted
Question about Onyx 24.4 Mixer
...do the same with eqs same thing happen Sounds like you've got the compressors etc. set wrong. Try connecting the tip and ring of a jack and putting this into the insert socket, if this works then
Usually answered in minutes!
124 Questions
35 Questions
24 Questions
14 Questions
