Questions & Answers for: Mitsubishi conect wires

...First you must check to see if you have installen the new system properly by checking all your conections..and that they are conected to the proper wires..the instructions provided for you frome ...

lights come on. no power with turning key. My interior lights come on when I first get in the car and as soon as I turn the key I lose all power. After a couple minutes I will regain power. I finally ...

...then 4 and finally 2. if it runs ,its probely only working on 3 cylinders you must have one lead conection not on properly Start your engine, disconnect 1 spark plug wire at a time and make a note ...

...of a 98 Mitsubishi Eclipse? Thank you. Carmen You may need to pick up a new plug and some **** conecters and replace the plug to the headlight.Remove the old plug from the light ,cut off the ...

I have 2001 Mitsubishi eclipse and the a/c compressor doesn't engage,tried freon wont take any,and checked relay it's good. Check your fuse to see if bad. Check conection of electric wire that ...

wires to the same conection. Then their should be one small wire connected to a different connector on the starter this is the power wire from the key switch. To check if this is the problem remove it

no power going the headlights and the dashboard lights dimly working. Turn the key and does not start. Replaced the battery, and same result no power, or going to the starter. What can it be? ...

check engine light stays on.i have had the o2 sensor and erg controll solinoid replaced now my maint reqd light has come on.i just passed 200000 miles.itried to clear check engine by dis conecting the

where is the ignition control module located follow the sparkplug wires. where they conect is the ignition module

install coil pack unplug wire conection unscrew bolts that hold it on, use a marker to write numbers on the plug wires so you can put them back in the right order on the new part. unplug them put new ...