Question about KP-51HW40 51" Rear Projection Television
...color and then backed them off untill I got a black screen and could see the channel display. When I finish adjusting them all, I turned the TV off for a few minutes, then back on and left it on for ...
...will see 4 knobs. Turn those knobs slowly till the arcs go away. The 3 knobs on the bottom are for color. the 3 on top are for the focus. That is correct. Got it! Goodbye blue wavy lines! Thank
...color) and the toner rubs off onto the paper - it's still powder. The paper then goes through an oven (developing drum or fuser) which melts the toner onto the paper. BaM! Out comes your document. A ...
...color. I think it's an electrical problem but I would like to confirm first. Appreciate any kind of answer. Regards If the redness fades away after it warms up, then it is the bulbs. Eventually they ...
...fades to blank but in a off-white color, I then have to adjust the screen a few times before it returns to normal again, also, this problem occurs when the screen is bumped or adjusted. Sometimes the ...
color fades at bottom of screen The color at the bottom of the screen is several shades lighter than at the top. Color gradually fades from top to bottom. Is this normal? Do I have a defective monitor
...color is faded more on the left hand side, Top to bottom, all colors line up. I replaced ALL four toners. ( they were getting low anyway thinking that this could be the problem.) Problem did not go ...
...fades very quickly. The Blue SCREEN setting is too high. These adjustments are located inside the TV behind the front panel. There are two screws behind covers and then a wooden panel to remove to ...
...color, which faded away in about 10 min. Burning in and fading away just like it did with the blue stuff. It still does that whenever there is a constant image on the screen for 2-3 min., just like ...
Question about D52WLCD 52" Rear Projection HDTV-Ready Television
...top of the picture tube and is too far away from the shadow mask, or something is wrong with the degaussing circuit. If none of these cases match what you see, try a more detailed description of the ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions