Questions & Answers for: collapsed lifter repair

Ad

Question about 2000 FXDWG Dyna Wide Glide

1 Answer

...Otherwise either the cam bearings have collapsed (there was a recall on TC88 motors for this years back and Harley may conribute a goodwill repair if done by a dealer) or a lifter roller has

Ad

Question about 2000 LS

1 Answer

collapsed lifter, a burnt valve or a bent push rod. The BEST solution is to recondition the heads and replace the cam & lifters. This will insure that any of the failing components are replaced and it

Ad

...collapsed lifter or it may just be normal if the engine has not been started up yet. If you are installing old lifters (or did not remove lifters for whatever repair you were performing) there may be ...

...collapsed lifter. How would I know for sure if I tried to verify myself? And how much would this cost/how hard to repair with just limited knowledge? I have found the exact noise I'm facing while ...

Question about 1999 Durango

1 Answer

...collapsed lifter" which is a reasonably common problem. It's not necessarily a serious problem but it can create headaches. Lifters are hydraulic, they have a system that allows them to get taller or ...

Question about 1995 Cutlass Supreme

1 Answer

...lifter the be sure it hasn't collapsed. Replacing the cam shaft can be a major repair especially if you have never done that, it would be advised to have a shop do this repair unless you are bold and ...

Question about 1996 Regal Olympic Gold

1 Answer

...collapsed lifter, this issue requires replacement of the camshaft and all lifters. I recommend against replacing only a collapsed lifter, as the cam lobe usually gets damaged, as the two parts are ...

Question about 1996 Regal Olympic Gold

2 Answers

...collapsed hydraulic valve lifter, if your car has hydraulic operated (from engine oil) valve lifters. At any rate, it sounds like something loose in the valve train-valve lifter with push rod ...

Question about 2000 S80

1 Answer

...lifter might be collapsed or stuck, could this be the problem, and is there a way to fix it with out having to rip it all apart to change the lifter? Yes the lifter or one of the valves could be ...

Question about 2004 FreeLander

1 Answer

...rod -(clean sludge or replace if bent)--lifter itselt-(flat spot- collapse -dry replace ) cam shaft -(flat spot repair or replace ) oil pressure /system (sludge or under pressure repair or replace

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7336 Answers

Marvin
Marvin

Level 3 Expert

85241 Answers

Brad Brown

Level 3 Expert

19163 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...